2 - Fix handling requests for LUNs other than 0 from SCSI-2 hosts.
3 - Handle glitches of the scsi signals to improve stability and operate with
4 multiple devices on the SCSI bus.
5 - Re-add parity checking. This can be disabled using scsi2sd-config if
7 - Added disconnect/reconnect support during SD card writes.
8 - Preliminary CDROM device support (incomplete)
9 - New configuration method. Data is now stored in flash to allow room for
10 custom VPD tables. The old eeprom configuration is ignored.
11 - Support for up to 4 SCSI targets.
12 - scsi2sd-config and bootloader hosts utilities are replaced by the
14 - Fix for SD cards with Samsung controllers which expect a "stop" bit
15 in each SD command over SPI.
16 - Hot-swap support. The SD card can be removed whenever it's not in use
17 (ie. the LED must be OFF when the SD card is removed)
20 - Fix blank SCSI ID in scsi2sd-config output.
23 - Allow building utilities on older Linux distros
24 - Resolve missing DLL issues for the Windows utilities
25 - Fix scsi2sd-config crash on Mac.
28 - Fixed several performance issues. Transfer rates up to 2.5MB/s are now
30 - Implemented the READ BUFFER scsi command for performance testing purposes.
31 - Added support for the new "yellow" v4.2 revision boards.
32 - Improved firmware uploading. bootloaderhost can now reset the board back
34 - Display firmware version in scsi2sd-config
35 - Add "--reset" parameter to scsi2sd-config
38 - Critical fix for writes when using non-standard block sizes.
39 - Fix to ensure SCSI phase bits are set atomically.
40 - Always return the requested number of bytes for a REQUEST SENSE command
41 This is required to support the Ensoniq ASR-10.
42 - Decreased (unused) heap and stack sizes to prepare for a memory
44 - Increased the maximum sector size to 8192 bytes.
47 - Fix to SCSI Reset handling to avoid lockups
48 - Bug fixes to improve standards compatibility
49 - Bug fix for Unit Attention Condition, which is now enabled by default.
50 scsi2sd-config can be used to disable it for those systems that
51 truely require it (eg. Mac Plus).
52 - Added Linked commands support.
53 - Added support for configurable sector sizes between 64 and 2048 bytes.
54 The sector size can be set via the MODE SELECT command using a SCSI
55 format utility, or via scsi2sd-config
56 - Powerbook firmware added
59 - Remove hacks around ATN handling, and implement proper select-with-atn
60 support. This fix is essential for communicating with some SCSI hosts.
61 All SCSI2SD users are urged to upgrade to this firmware version.
62 - More fixes to support Apple HD SC Setup (thanks to Doug Brown!)
63 - Fixes to support SCSI1 initiators
64 * Support non-arbitrating initiators.
65 * Support single-initiator option.
66 * Set CCS response format flag in INQUIRY response.
69 - Fixes for better SCSI reset handling
70 - Fix for reading the last sector of the SD card.
71 - Performance improvements. 2.5x read, 2x write performance.
75 - Fixes to support formatting with Apple HD SC Setup. This is very slow,
76 Apple Drive Setup is preferred
77 - Reliability improvement for rejecting unknown SCSI messages.
78 - Reliability improvements for SD card initialisation and reading.
82 - Initial public release.