SCSI2SD FAQ

Small loads/stores work, but SCSI2SD fails with large writes

This is often a sign that only one end of the SCSI bus is terminated.

A common cause is the use of a DB25 connector. Pin 25 is supposed to provide power to run the terminator yet several samplers do not connect this pin. Close the jumper labelled "J3 TERMPWR" on the SCSI2SD to provide direct power to the terminators.

Does SCSI2SD work with samplers ?

There are compatibility issues with the Akai MPC3000, most other samples should work ok.

Thanks to Carl at Precious Sound for putting in the time to test SCSI2SD.

Does SCSI2SD support 256 bytes-per-sector ? More than 512 bytes-per-sector

Yes, from firmware version 3.3, set via the scsi2sd-config utility.